Function Switch - KPS PA70 Manuel D'instructions

KPS-PA70 • Digital clamp meter
to upper range. Continue to the top range, then continue to press this key
to change to the bottom range, followed by recycling. If this key is pressed
more than 2 sec, it will switch back to automatic measuring range state.
4.3 Frequency/Duty Ratio Switch
• When the meter is in AC voltage mode, if "Hz/%" button is pressed, the me-
ter will measure Hz, and measure AC voltage, AC current signal frequency.
Click "Hz/%" button again, the meter will measure DUTY cycle, and measure
voltage and current signal duty ratio. If it is in HZ/DUTY position, pressing
HZ % key will switch between HZ and DUTY by recycling.Si se pulsa de
nuevo el botón "HZ/%", el instrumento regresará al modo de medición de
tensión y corriente.
NOTE:
The meter is in the maximum/minimum value measurement state, it can't
switch to frequency, duty ratio measurement mode.
4.4 Maximum/Minimum Measurement Choice
• Press "MAX/MIN" key to enter MAX mode, and always keep measurement
maximum value; press "MAX/MIN" key again, the meter will enter minimum
value measurement state; press "MAX/MIN" key for the third time, the meter
will display the difference of maximum and minimum value; press "MAX/
MIN" key to repeat the above operations by recycling.
• After entering MAX or MIN mode, it will automatically save the measured
maximum or minimum value.
• If the user presses "MAX/MIN" key more than 2 sec, the meter will restore
normal measuring range.

4.5 Function switch

• In the resistance mode, press "FUNC" button, it will switch among resistan-
ce, diode and continuity detection by recycling.
• In the voltage and current mode, press "FUNC" button to switch between
AC and DC. Δ
4.6 REL/INRUSH Measurement
• REL/INRUSH button is relative value measurement button. Operated by tap-
ping this button, it will enter relative value measurement mode,. The current
display value can be stored in the memory as reference value. When the
39