KPS PA70 Manuel D'instructions page 27

KPS-PA70 • Digital clamp meter
• When measuring, if the voltage to be measured is more than 60 V DC or 30
V AC (RMS), always keep your fingers behind finger protection device
• Do not measure voltage greater than AC 750V.
• In the manual measuring range mode, when measuring an unknown value,
select the highest measuring range first.
• Before rotating conversion switch to change measuring function, remove
probe from the circuit to be measured.
• Don't measure resistor, capacitor, diode and circuit connected to power.
• During the test of currents, resistors, capacitors, diodes and circuit connec-
tions, be careful to avoid connecting the meter to a voltage source.
• Do not measure capacitance before capacitor is discharged completely.
• Do not use the meter in explosive gas, vapor or dusty environments.
• If you find any abnormal phenomena or failure on the meter, stop using the
meter.
• Unless the meter bottom case and the battery cover are completely fastened
completely, do not use the meter.
• Don't store or use the meter in the conditions of direct sunlight, high tempe-
rature and high humidity.
1.3 Mark
Note (Important safety information. Refer to the operation manual)
Can be used for dangerous electric conductor.
Double insulation protection (class II)
According to pulse voltage tolerance protection level provided by
CAT III IEC 61010-1 standard overvoltage (installation) level III and pol-
lution degree 2.
The meter complies with EU standard
Grounding
1.4 Maintenance
• Don't try to open the meter bottom case to adjust or repair. Such operations
27