Selecting And Setting The Target Temperature; Selecting And Setting The Mixer (Valve) Direction Of Rotation; Selecting The Hydraulic Diagram And Setting Of The Minimum, Maximum And Target Temperatures; Selecting The Hydraulic Diagram - evenes MMF 230.10.120 Manuel D'installation

7 | SAFETY INSTRUCTIONS BEFORE AND DURING COMMISSIONING

7.2.2 Selecting and setting the target temperature

1s
basic display

7.2.3 Selecting and setting the mixer (valve) direction of rotation

5s
basic display
7.3 Selecting the hydraulic diagram and setting the minimum,
maximum and target temperatures
The settings for the 'Hydraulic diagram' and the minimum and maximum temperatures can only
be selected during commissioning in the 'Controller commissioning' mode.

7.3.1 Selecting the hydraulic diagram

1. Return flow temperature
maintenance
and
open counter
clockwise
Return temperature
control
The setting can be adjusted with the buttons
+ and – in 1° steps and confirmed with the
button. The change is immediately shown on the
display and the fixed setpoint controller operates
under the new setting.
open clockwise
2. Flow temperature control
FIXED SETPOINT CONTROLLER MMF 230.10.120
The setting can be
adjusted with the + and –
buttons and confirmed
with the button.
Flow temperature
control
35