Turbo; Sleep Function; Timer Function (Connection Using Timer) - Saunier Duval SDH 31-026 NW Notice D'utilisation

9- OPERATING INSTRUCTIONS

9.9 TURBO

Press TURBO button during COOL or HEAT mode operation. The air rate can be set to HIGH and continue to
operate for 20 minutes. Press TURBO again to release the Turbo mode operation..
NOTE!
The air rate cannot be changed during Turbo mode operation.

9.10 SLEEP FUNCTION

The COOL, DRY, HEAT, AUTO modes can be set during the nighttime hours to reduce the operation sound
when sleeping, etc..
In order to activate:
With the unit connected
Press the SLEEP button to reduce the air flow sound from the indoor unit..
Press the SLEEP button once more to release this mode.
The SLEEP mode should only be used at night. If it is used uring the day, the cooling/heating capacity will be
reduced since the room temperature is too high (COOL mode).
The unit is operational for a maximum of 24 hours in SLEEP mode.
In COOL mode
The ambient temperature gradually increases 2ºC in relation to the configured one to ensure that the
temperature does not drop excessively during sleeping hours.
In HEAT mode
The ambient temperature gradually decreases 5ºC in relation to the configured one to ensure that the
temperature does not rise excessively during sleeping hours.
- During the first operating hour of the SLEEP function, the ambient temperature will drop 2ºC below the
configured temperature.
- Once an hour has elapsed, the temperature will drop 2ºC more.
- Once three hours have elapsed, the temperature will rise 1ºC.
- The unit will be operational for a further three hours before stopping.

9.11 TIMER FUNCTION (CONNECTION USING TIMER)

The unit can be automatically connected/disconnected using the timer.
In order to set the unit to disconnect automatically:
With the unit connected:
Press the TIMER button.
The timer settings range from 1 to 24 hours. Each time the TIMER button is pressed the sequence will be as
follows: 1 - 2 - ... up to 24 and cancel (no indication). If you continue pressing it starts counting all over again
The selected time will be shown on the remote controller display. During the countdown process the
display will always show the remaining time
10