Fireplace Installation; Installation - Dimplex XLF50 Manuel Du Propriétaire

Fireplace Installation

CAUTION: Ensure installation
does not allow fireplace to be in
direct contact with building vapor
barrier or insulation and meets all
local building code.
!
NOTE: A dedicated, properly
fused 15 Amp circuit is required,
rated for the appropriate voltage
(120V, 240V).
WARNING: Construction
and wiring must comply with
local building codes and other
applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
WARNING: To reduce the risk
of fire, electric shock or injury to
persons, always use a licensed
electrician.
WARNING: To reduce the
risk of fire, do not store
or use gasoline or other
flammable vapors or liquids
in the vicinity of the heater.
1. Select a location that
is not susceptible to
moisture and is away from
drapes, furniture and high
traffic.
2. Unpack the fireplace and
hardware from the box.
!
NOTE: Leave the front
glass and partially reflective
glass, safely, in the box until
the time you are ready to
install it.
3. Store the fireplace in a safe,
dry and dust free location until
you are ready to install the
fireplace.

Installation

CAUTION: Two people will be
required for various steps of
this procedure.
This design of this unit allows
three options for installation:
partial recess, flush mounted or
sub-surface mounted.
Figure 2
2" x 6"
5 1/2" (14.0 cm)
2" x 4"
3 1/2" (9.0 cm)
XLF50: 50 5/8" (128.6 cm)
XLF74: 74 5/8" (189.7 cm)
XLF100: 100 5/8" (255.7 cm)
16"
(40.6 cm)
7