Handling Diamond Dry-Cutting Discs; Tools And Accessories; Disposal; Scope Of Supply - Baier Elektrowerkzeuge BDN 125 Mode D'emploi

8 Handling diamond dry-
cutting discs
•
Always use and store diamond dry-cutting
discs in accordance with the manufacturer's
instructions.
•
Too soft diamond segments:
f Diamond dry-cutting discs wear too quickly
at very high removal rate.
Remedy: The material to be machined
requires diamond dry-cutting discs with a
harder bond.
•
Too hard diamond segments:
f The diamond grains become blunt and do
not break out of the bond. The diamond dry-
cutting discs no longer have any cutting
power.
Remedy: The material to be machined
requires diamond dry-cutting discs with a
softer bond.
•
In the event of loss in cutting power
(recognisable by intensity of flying sparks)
resharpen the diamond dry-cutting discs by
making several cuts in abrasive material, e.g.
sandstone or with the BAIER professional
whetstone (ID No. 15453).
•
Work with low pressure. Increased pressure
causes increased wear.
•
Excessive cutting pressure can cause material
fatigue in the base metal and therefore the
formation of cracks. Before use, ensure that
there are no cracks in the diamond dry-cutting
disc.
•
Diamond dry-cutting discs are designed for
straight cuts. If used to cut curves the blade
becomes deformed, causing internal cracks and
segments to break off (see "Chap. 3.5 Intended
use") – Risk of injury!
•
The diamond cutter should plunge into the wall
only after the working speed has been reached.
11

Scope of Supply

Please refer to the enclosed delivery note for the
individual scope of supply of a customer-specific
order.
Diamond
channel cutter
type
Basic selection ID. No.
BDN 125
x included in scope of supply
( ) Number of diamond dry-cutting discs supplied
Diamond
dry-cutting disc
8799 x (2) lD No. 7237
9

Tools and Accessories

•
BAIER diamond dry-cutting discs for all kinds of
different areas of use.
•
BAIER BMH 622 chipping hammer
•
BAIER special dust extractor
•
Professional whetstone (ID. No. 15453)
10

Disposal

Recycle the machine and its packaging
in an environmentally friendly way in
accordance with the provisions applicable
in your country.
Please refer to the table below for the scope of
supply of basic models. Please contact your dealer
if parts are missing or damaged.
Case
8780
Open-ended spanner
13 / 17
3384
| 33 |