Finish Cutting Process; Cleaning; Maintenance - Baier Elektrowerkzeuge BDN 125 Mode D'emploi

EN
NOTE
The diamond cutter also switches off if the
diamond dry-cutting disc has insufficient cutting
power. In this case, check whether you have
chosen the correct diamond dry-cutting disc for the
relevant use.
Note and follow the information and instructions
on handling diamond dry-cutting discs (see
page 33).
5.5

Finish cutting process

DANGER
Risk of injury due to uncontrolled kickback of the
diamond cutter, caused by canting of the diamond
cutter in the cut chase.
Î Always wait for the diamond dry-cutting discs to
stop completely before removing the diamond
cutter from the cut chase.
•
7 Switch off the diamond cutter at the
switch (3), wait until the diamond dry-cutting
discs have completely stopped, and then
remove the discs from the chase and put down
the cutter.
CAUTION
Risk of breakage of diamond dry-cutting discs!
Î Never use the diamond dry-cutting discs to
break out the ridge of the chase.
•
8 Use a suitable tool (e.g. chisel, BAIER
BMH 622 chipping hammer) to break out the
ridge of the chase in the wall.
NOTE
Blunt diamond dry-cutting discs can be
resharpened if necessary using BAIER whetstones
or other suitable materials.
Note and follow the information and instructions
on handling diamond dry-cutting discs (see
page 33).
| 32 |
6

Cleaning

DANGER
Risk of injury due to electric shock.
Î Disconnect the mains plug before carrying out
any work on the diamond channel cutter.
The machine must be cleaned after each cutting
work session.
•
Carefully clean the machine and blow out with
compressed air.
•
Ensure handles are dry and free from grease.
•
Keep the machine's ventilation slots clean at all
times.
7

Maintenance

DANGER
Risk of injury due to electric shock.
Î Disconnect the mains plug before carrying out
any work on the diamond channel cutter.
The diamond channel cutter must be serviced at
least once a year. Further, servicing will be neces-
sary depending on the wear of the carbon brushes.
Only servicing and repair firms authorised by
Maschinenfabrik OTTO BAIER GmbH may carry
out maintenance of the machine. Also ensure that
original BAIER spare parts and original BAIER
accessories only are used.