Baier Elektrowerkzeuge BDN 125 Mode D'emploi page 21

Imprint
Version: V01 / 2015-10
Copyright:
Maschinenfabrik
OTTO BAIER GmbH
Heckenwiesen 26
D-71679 Asperg
It is prohibited to forward or reproduce this
document or to exploit and disclose its contents,
unless expressly permitted. Any infringements will
result in liability to pay compensation for damages.
All rights reserved in case of patent, utility model or
design registration.
This instruction manual has been prepared with the
greatest possible care. Nonetheless, OTTO BAIER
GmbH does not accept any liability whatsoever for
possible errors in this instruction manual and their
consequences. Equally, no liability whatsoever is
accepted for direct or consequential damage or
losses resulting from improper use of the machine.
The national health and safety regulations and the
requirements of this instruction manual are to be
observed when using the machine.
All product names and brand names used are the
property of the holder and are not explicitly marked
as such.
Subject to change without notice.
Contents
1 About this instruction manual ........... 22
1.1 Important information ............................. 22
1.2 Symbols used in the instruction manual 22
2 Safety Instructions .............................. 22
2.3 Workplace safety .................................... 22
2.4 Electrical safety ...................................... 22
2.5 Safety of people ...................................... 23
2.6 Using and handling the power tool ......... 23
2.7 Service .................................................... 24
2.8 Machine-Specific Safety Instructions .... 24
2.8.1 Operating personnel requirements ........ 24
2.8.2 Workplace safety .................................... 24
2.8.3 Electrical safety ...................................... 24
2.8.4 Safety of people ...................................... 25
2.8.5 Hazards when using and handling the
power tool ............................................... 25
2.8.6 Service / Maintenance / Repair .............. 27
2.8.7 Explanation of the pictograms on the
diamond channel cutter .......................... 27
3 Technical Characteristics ................... 28
3.1 Technical specifications ......................... 28
3.2 EC Declaration of Conformity ................ 29
3.3 Machine characteristics ......................... 29
3.4 Machine parts and controls .................... 29
3.5 Intended use ........................................... 29
4 Before Starting Work ........................... 30
5 Operation and Control ......................... 30
5.1 Fit or replace diamond dry-cutting discs 30
5.2 Adjust cutting depth ................................ 31
5.3 Connect dust extractor ........................... 31
5.4 Switch on the diamond cutter and cut .... 31
5.5 Finish cutting process ............................ 32
6 Cleaning ................................................. 32
7 Maintenance .......................................... 32
8 Handling diamond dry-cutting discs
9 Tools and Accessories ........................ 33
10 Disposal ................................................. 33
11 Scope of Supply ................................... 33
12 Warranty ................................................ 34
33
| 21 |