Ec Declaration Of Conformity; Machine Characteristics; Machine Parts And Controls; Intended Use - Baier Elektrowerkzeuge BDN 125 Mode D'emploi

3.2

EC Declaration of Conformity

We herewith declare, with sole
responsibility, that this product conforms
to the following standards or normative
documents:
in accordance with the provisions of the Directives
2006 / 42 / EC; 2014 / 30 / EU; 2011 / 65 / EU
The head of development is authorised to write the
technical documents.
These are available from:
Maschinenfabrik OTTO BAIER GmbH,
Heckenwiesen 26,
D-71679 Asperg
Thomas Schwab
Managing Director
Asperg, 01.09.2014
3.3

Machine characteristics

Starting current limitation and soft-start
The switching on current of the machine is a
multiple of the nominal current. The starting current
limitation reduces the switching on current to such
an extent that a fuse (16 A slow) does not trip.
Electronic soft-start for safe handling prevents
sudden starting-up of the machine when it is
switched on.
Starting current limitation and soft-start
The electronics adjust the speed with increasing
load.
In case of lengthy overload the electronics switch
to reduced speed. The machine continues running
slowly to cool the motor winding. After switching the
machine off and on it can be used once again within
the nominal load range.
EN 60745
Wilfried Hartmann
Factory Manager
3.4

Machine parts and controls

(See Figure 1 )
1 ON / OFF switch
2 Handle
3 Rear roller
4 Nozzle for dust extractor hose connection
5 Rotation direction arrow
6 Washer
7 Hexagon head screw (right-hand thread)
8 Diamond dry-cutting disc
9 Protective hood
10 Front roller
11 Front handle
12 Clamping lever
13 Spindle lock
(concealed, see Item (7) in Figure
 Working direction
3.5

Intended use

The diamond cutters listed in this instruction manual
are only approved for dry cutting in masonry (brick,
lime-sand blocks, undressed stone) and concrete.
They must not be used for wet cutting or for cuts in
metal, glass, wood, etc.
•
Observe the relevant regulations in your
country for the materials to be machined.
•
The diamond cutters are only approved for
use together with a dust extractor, which is
suitable for stone dust (e.g. BAIER Special Dust
Extractor).
WARNING
Risk of injury due to cracking and breaking of
the diamond dry-cutting disc (bits of disc flying
around).
Î Diamond dry-cutting discs are designed for
straight cuts.
If used to cut curves the diamond dry-cutting
disc becomes deformed which causes internal
cracks and segments to break off.
•
Do not expose diamond dry-cutting discs to
lateral pressure.
•
Never use diamond dry-cutting discs for rough
grinding.
3
| 29 |