Retevis RT666 Mode D'emploi page 8

WARNING
Bulgaria (BG), Czech Republic (CZ), Denmark (DK), Germany (DE), Estonia
(EE), Ireland (IE), Greece (EL), Spain (ES), France (FR), Croatia (HR), Italy
(IT), Cyprus (CY), Latvia (LV), Lithuania (LT), Luxembourg (LU), Hungary (HU),
Malta (MT), Netherlands (NL), Austria (AT), Poland (PL), Portugal (PT),
Romania (RO), Slovenia (SI), Slovakia (SK), Finland (FI), Sweden (SE) and
United Kingdom (UK).
For the warning information of the frequency restriction, please refer to the
package or manual section.
• Disposal
The crossed-out wheeled-bin symbol on your product, literature, or
packaging reminds you that in the European Union, all electrical and
electronic products, batteries, and accumulators (rechargeable batt-
eries) must be taken to designated collection locations at the end of
their working life. Do not dispose of these products as unsorted
municipal waste. Dispose of them according to the laws in your area.
IC Requirements:
Licence-exempt radio apparatus
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada's licence-exempt
RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage;
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
RF Exposure Information
• DO NOT operate the radio without a proper antenna attached, as this may
damage the radio and may also cause you to exceed RF exposure limits. A
proper antenna is the antenna supplied with this radio by the manufacturer
or an antenna specifically authorized by the manufacturer for use with this
radio, and the antenna gain shall not exceed the specified gain by the
manufacturer declared.
• DO NOT transmit for more than 50% of total radio use time, more than 50%
of the time can cause RF exposure compliance requirements to be exceeded.
• During transmissions, your radio generates RF energy that can possibly
cause interference with other devices or systems. To avoid such interference,
10
turn off the radio in areas where signs are posted to do so.
• DO NOT operate the transmitter in areas that are sensitive to electromagnetic
radiation such as hospitals, aircraft, and blasting sites.
• Portable Device, this transmitter may operate with the antenna(s) document-
ed in this filing in Push-to-Talk and body-worn configurations. RF exposure
compliance is limited to the specific belt-clip and accessory configurations as
documented in this filing and the separation distance between user and the
device or its antenna shall be at least 2.5 cm.
• Mobile Device, during operation, the separation distance between user and
the antenna subjects to actual regulations, this separation distance will ensure
that there is sufficient distance from a properly installed externally-mounted
antenna to satisfy the RF exposure requirements.
• Occupational/Controlled Radio, this radio is designed for and classified as
"Occupational/Controlled Use Only", meaning it must be used only during the
course of employment by individuals aware of the hazards, and the ways to
minimize such hazards; NOT intended for use in a General population/
uncontrolled environment.
• General population/uncontrolled Radio, this radio is designed for and
classified as "General population/uncontrolled Use".
RF Exposure Compliance and Control Guidelines and Operating
Instructions
To control your exposure and ensure compliance with the occupational/
controlled environment exposure limits, always adhere to the following
procedures.
Guidelines:
• User awareness instructions should accompany the device when transferred
to other users.
• Do not use this device if the operational requirements described herein are
not met.
Operating Instructions:
• Transmit no more than the rated duty factor of 50% of the time. To Transmit
(Talk), push the Push to Talk (PTT) button. To receive calls (listen), release
the PTT button. Transmitting 50% of the time, or less, is important because
the radio generates measurable RF energy exposure only when transmitting
in terms of measuring for standards compliance.
• Transmit only when people outside the vehicle are at least the recommended
minimum lateral distance away from a properly installed according to
installation instructions, externally mounted antenna.
• When operating in front of the face, worn on the body, always place the radio
WARNING
11