System Configuration Examples - Sony PWS-100TD1 Mode D'emploi

System Configuration Examples

Connect VTRs and external monitors to the SDI
connectors of the unit, and drive units to the USB
connectors on the rear panel. You can select a 2-input/
2-output, 3-input/1-output, or 4-input system
configuration by configuring SDI settings in the web
application.
2 inputs/2 outputs
Connect VTRs to the SDI 1 and SDI 2 connectors, and
external monitors to the SDI 3 and SDI 4 connectors. You
can use this configuration to digitize video from two VTRs
in parallel.
VTR
REF
Operator Operator
HD/SD SDI
RS-422
HD/SD SDI
RS-422
REF IN
Sync signal
Notes
• If multiple VTRs are connected, make sure that all VTRs are synchronized
(±1H).
• Set the EE/PB setting of the VTR to PB.
Manager
Gigabit Ethernet
HD SDI
HD SDI
USB 3.0
PWS-100TD1
USB 3.0
External monitor
Drive unit
21
Overview