Tecno-gaz Sterilair Pro SA210ZSA Manuel De L'utilisateur page 42

Unité de recirculation aux uvg1 (ultraviolet germicidal irradiation) pour la stérilisation de l'air
Masquer les pouces Voir aussi pour Sterilair Pro SA210ZSA:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

ENGLISH
2.
Press the key 1...7 ( ) to enter the day of the week (1=Monday, 7=Sunday) or day
blocks. The following day blocks can be selected by continuing to press the same
key:
1 to 5
The arrows on the display indicate the days of the week.
3.
Press the keys h (
4.
Press the key P ():The subsequent switching point (which will be even, therefore
switch-ff) is viewed.
5.
Repeat steps 2 to 4 for the times requested.
After having set the required switching: move the sliding switch  to AUTO and
6.
the switch  to RUN.
The programmer now works according to the set program.
Control, modification and cancellation of switching times
Move the sliding switch  to P .
1. Control: Press the key P as much as necessary to check the switching point on the
Display.
2. Modification:
• Use the key P to position yourself at the switching point to be modified.
Press the keys 1...7 ( ) to change the day of the week.
• Press the keys h () and m () to change the switching time as instructed
previously.
3. Cancellation:
• Use the key P to position yourself at the switching point to be modified.
Then press the keys "-X->" ( ) and P (  ) simultaneously for 3–4 seconds. A flashing
0:00 appears on the display and the switching point is cancelled.
If control, modification or cancellation is finished, move the sliding switch  to RUN.
-X-> Skip Function (soft-override)
The Skip Function changes the switching setting of the connected device until it reaches
the following program.
For example: if the device is ON, pressing the key Skip '-X->' immediately switches it OFF
and vice versa.
1. Move the sliding switch  to RUN.
2. Press the key Skip '-X->'. The device will change switching respect to the set mode.
The symbol Skip (-X->) appears on the Display (wait 3-4 seconds).
3. Then pressing the key Skip '-X->' restores the Skip Function.
Precautions for Skip Function:
• The number and symbol appear on the Display after an interval of 3 seconds.
1 to 7
1 to 6
) and m (
)to set the time.
6 to 7
14

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sterilair proSa210zsa

Table des Matières