deuter KID COMFORT ACTIVE Mode D'emploi page 14

4
4.1
The width of the seat cushion matches
the adjusted seat height and, in combination
with the specific foot loop construction en-
sures the sitting posture is ergonomic. Thread
the foot loop straps either into the upper
or lower
child's seating position. During this process,
keep the detached foot loop straps out of reach
of children. As a general rule: mount the foot
loops in the upper buckle for smaller children
with a higher seating position
taller children with a lower seat, mount the
footrests in the lower buckle
adjust the foot loops to the required height
by tightening or releasing the straps:
4.2
The width increases with the height of
the seat to guarantee a natural slightly splayed
'frog leg' position for small children. The legs
should be at a slight angle in the foot loops.
4.3
The lower the seat, the narrower the
width of the seat, for an upright sitting po-
sition for slightly taller children. The legs
should neither dangle nor should they be at
too sharp an angle.
Finally, tighten the bottom strap to prevent
the foot from slipping out of the foot loop.
KidComfort_Booklet_Insert_22.indd 14 KidComfort_Booklet_Insert_22.indd 14
Adjust the height of
the foot loops
b)
position/buckle depending on the
(4.2)
(4.3)
5
Fitting the rain
cover and sun shade
NOTE! Check your child's skin regularly be-
cause small children have very sensitive skin.
In strong sunlight, protect your child from UV
rays by using a sun shade (available to buy
a)
as an accessory for the Kid Comfort Active
model, included with the Kid Comfort mod-
el and integrated in the Kid Comfort Pro mod-
el). Accessories or spare parts should only be
purchased directly from the manufacturer or
from specialist retailers.
. For
5.1
Sun Shade Kid Comfort & Kid Comfort
Active: insert rods into the two fabric chan-
. Then
nels on the front of the head rest.
5.2
Sun Shade Kid Comfort Pro: open the
zipper on the head rest fully and pull out the
integrated sun shade.
5.3
Finally, fix the sun shade with the
buckles at the height of the chin pad to keep
it in place.
The rain/wind cover (available separately) can
be stretched over the top (not shown). Fits
over all deuter child carriers with a sun shade.
6
Putting on
and taking off
6.1
Double-check the safety harness and
the side entry are properly secured. Stand at
the back of the child carrier. Place one hand
02.03.21 16:36 02.03.21 16:36