ARO SHC5065 Notice D'utilisation page 32

CLEANING AND MAINTENANCE
3. Pull the inner glass panel from its seat
(in the lower section of the door).
fig. D.
4. Clean the panel with warm water with
some cleaning agent added.
Carry out the same in reverse order to
reassemble the inner glass panel. Its
smooth surface shall be pointed up-
wards.
Important! Do not force the upper
strip in on both sides of the door at
the same time. In order to correctly fit
the top door strip, first put the left end
of the strip on the door and then press
the right end in until you hear a "click".
Then press the left end in until you hear
a "click".
D
1
3
2
1
Removal of the internal glass panel.
3
2
Replacement of the oven light bulb
In order to avoid the possibility of an
electric shock ensure that the appliance
is switched off before replacing the bulb.
• Set all control knobs to the position
disconnect the mains plug.
• Unscrew and wash the lamp cover and
then wipe it dry.
• Unscrew the light bulb from the socket,
replace the bulb with a new one – a
high temperature bulb (300°C) with the
following parameters:
- voltage 230 V
- power 25 W
- thread E14.
• Screw the bulb in, making sure it is
properly inserted into the ceramic
socket.
• Screw in the lamp cover.
32
/0 and
