Installation - Franke FTC 6462 Mode D'emploi Et Installation

INSTALLATION

• The Hood can be fitted directly on the
lower surface of the Wall Units (at mini-
mum 650 mm above the Cooker Top) using
the snap-on Side Supports.
• Make an opening on the lower surface of
the Wall Unit, as indicated.
• Insert the flange 9 to the lower air outlet
opening.
• Screw the closing profile 20 onto the rear
part of the hood, using the screws 12e (2.9
x 12.7) provided.
• Open the comfort panel; turn the hooks and
remove the panel by slightly pressing the
rear side.
• Open the glass panel.
• Remove the metal grease filters one by one
by turning the hooks provided.
• Close the glass again.
• Insert the hood until the snap-on side sup-
ports click into place.
• Open the glass panel.
• Lock in position by tightening the screws
Vf from underneath the hood.
• If necessary, adjust the whole filter holder
unit and proceed as follows:
• Loosen the four adjustment screws Vr and
close the glass panel again.
• Move the entire filter holder unit until it is
properly aligned with the self.
• Keeping the hood casing still, remove the
glass panel and lock the adjustment screws
again.
• The hood can now be fastened to the self
using the four screws 12a (3.5 x 16) pro-
vided.
• Replace the metal grease filters.
• Close the sliding panel again and put the
comfort panel into its seat.
EN
Drilling the Support surface and Fitting the Hood
20
162
12e
503
Vf
Vr
12a
12a
1
16
6