Kenmore 6002 Guide D'utilisation Et D'entretien page 12

If you experience
Cycle time too short
Lint on load
Stains on load or drum
Loads are wrinkled
Odors
Load is too hot
12
All manuals and user guides at all-guides.com
TROUBLESHOOTING cont.
Possible Causes
Automatic cycle ending early.
Lint screen clogged.
Dryer fabric softener not properly
used.
Was the load not removed from
dryer at the end of the cycle?
Dryer overloaded.
Have you recently been painting,
staining, or varnishing in the area
where your dryer is located?
Is the electric dryer being used for
the first time?
Were laundry items removed from
the dryer before the end of the
cycle?
Was a high temperature cycle
used or was Dry Temp set on high?
The load may not be contacting the sensor strips. Level the dryer.
Use Time Dry for very small loads. Change the Dry Level
setting on Auto Dry Cycles.
Increasing or decreasing the Dry Level setting will change the
amount of drying time in a cycle. If loads are consistently ending
too early, see "Changing the EvenHeat™ Auto Dry Cycle Settings
to Increase Drying Time".
Lint screen should be cleaned before each load.
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).
These will not transfer to other clothing.
Select Wrinkle Guard feature to tumble the load without heat
™
to avoid wrinkling.
Dry smaller loads that can tumble freely reduce wrinkles from
forming.
If so, ventilate the area. When the odors or fumes are gone from
the area, rewash and dry the clothing.
The new electric heating element may have an odor. The odor
will be gone after the first cycle.
Allow Cool Down to finish before removing laundry from dryer.
All cycles are cooled slowly to reduced wrinkling and make it
easier to handle. Items removed before Cool Down may feel
very warm.
Select a lower temperature, and use an automatic drying cycle.
These cycles sense the temperature or the moisture level in the
load and shut off when the load reaches the selected dryness.
This reduces overdrying.
Solution