Philips SRP4004/86 Mode D'emploi page 7

• If the device does not respond at all or not to all of the key
2.3.1
1
2
2.3.2
When correctly set up, the remote control should be able
to operate all your devices. However, when using the remote
control for the first time it might occur that some keys do
not yet function as expected.
In this case you can have the remote control search for
alternatives.
Improving keys is not possible when the code was found
during full database search (with code '9, 9, 9, 9').
During initial setup
1
2
• I f the key still does not function as expected, try pressing
After initial setup
1
SRP4004_86_Manual.indd 7
commands or if you cannot find the code for your brand,
enter '9, 9, 9, 9' in step 3 and continue with step 4. The
remote control will now search its full database for a code
that works with your TV. Full database search may take up
to 15 minutes.
Setting up the remote control for other devices
(STB, DVD player / recorder and VCR)
Make sure the device is turned on, fully operational and
able to respond to remote control commands. E.g. insert
a disc in the DVD player / recorder or a video cassette in
the VCR.
Then follow steps 2 to 6 of 'Setting up the remote
control for your TV'. Make sure to use the correct device
selection key:
Improving keys
Note
Make sure the receiving device is able to respond.
E.g. when you try to repair the Play key for your DVD
player, make sure to insert a DVD into the DVD player
otherwise the Play key is not able to function.
Press the key that does not function, keep it pressed and
immediately release it when the device responds.
Repeat this for every key that does not function.
it again for a longer period of time.
Make sure the receiving device is able to respond.
E.g. when you try to repair the Play key for your DVD
player, make sure to insert a DVD into the DVD player
otherwise the Play key is not able to function.
, or .
EN
7
28-05-09 18:17