Automatic Defrosting; Cleaning And Maintenance - Wood's MDK11 Mode D'emploi

Operating Instructions
GB

AUTOMATIC DEFROSTING

Wood's dehumidifiers are fitted with
a control unit which ensures that the
cooling coils are defrosted automatically
when needed. The control shuts down
the compressor, which causes the cooling
of the coils to stop. The fan continues
to draw the air at room temperature
through the dehumidifier and thus melts
the ice, and the water runs down into
the reservoir. This defrosting system
means that the dehumidifier works at
temperatures as low as +5˚C.
FAN
The fan ensures that air flows through the
dehumidifier. Moist air is sucked in from
the rear and goes via the cooling coil and
the vaporizer to come out dry and warm
at the top of the dehumidifier.

CLEANING AND MAINTENANCE

Wood's dehumidifiers require
cleaning of filter, to maintain their high
dehumidifying capacity.
-- The cooling coils are best cleaned with a
rag and warm water-be careful
- The fan motor is permanently lubricated
and requires no maintenance.
NOTE: Always disconnect the
cord before cleaning.
HINTS:
- Sometimes it may be useful to use a frost
guard or heater fan to make sure that the
temperature does not fall below +5˚C.
- For maximum dehumidifying power in
a room, it is recommended that the air
supply from outside and from adjoining
rooms is minimized – close doors and
ventilators.
- Put in the center of the room
- Increase temperature. for faster
8
dehumidification
( warm air carries more water.)
- Use frost guard if temperature falls below
+5°C
- Higher dehumidification in autumn /
summer because outside air is warm and
humid. (Absolute humidity is normally
higher).
WHEN THE DEHUMIDIFIER REQUIRES
SERVICING
If the dehumidifier requires servicing,
you must first contact the retailer. Proof
of purchase is required for all guarantee
claims.
GUARANTEES
2 year´s guarantee against faults in
manufacture. Note that the guarantee is
only valid with receipts from purchase of
machine.
NOTE! Get a 3-years warranty!
Register at warranty-woods.com
Please visit woods.se for more
information
Recommended limits for use
Temp. MDK11/MDK13 +5˚C to +35˚C
Relative humidity: 30% to 90%
Recommended humidity level: appr.
50% RH
IMPORTANT! - Wood's
dehumidifiers must be connected
to an grounded power source.
The power source sould be
220V-240V 50Hz
We reserve the right for any errors, or
product changes. For changes and
updates visit woods.se
04