Troubleshooting Guide - Porter Cable PIN138 Manuel D'instructions

TROUBLESHOOTING GUIDE

MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART
BELOW. FOR MORE SERIOUS OR PERSISTENT PROBLEMS, CONTACT A PORTER-
CABLE SERVICE CENTER OR CALL 1 888 848-5175.
To reduce the risk of serious personal injury, ALWAYS disconnect
air from tool before all repairs.
SYMPTOM PROBLEMS
Air leak near top of Loose screws.
tool or in trigger area
Worn or damaged
o-rings or seals.
Tool does nothing or Inadequate air supply.
operates sluggishly
Worn or damaged
o-rings or seals.
Fastener jammed in nosepiece. See Clearing a Jammed Nail.
Air leak near Loose screws.
bottom of tool
Worn or damaged
o-rings or bumper.
Tool jams frequently Incorrect fasteners.
Fastener fragments
jammed in nosepiece.
Fasteners loaded incorrectly.
Damaged fasteners.
Magazine or nose screws loose Tighten screws.
Magazine is dirty.
Driver tip is worn or
damaged.
Tool does not fire Only a few fasteners are
left in the magazine
Other
Height (inch/meter)
Width (inch/meter)
Length (inch/meter)
Weight (lbs/kg)
Recommended Operating Pressure 60-100 psi (4.1 to 6.9 bar)
Air Consumption per 100 cycles
Loading capacity
Lubrication
TOOL SPECIFICATIONS
PIN138
7.5/.19
1.9/.05
8.1/.21
2.1/0.95
1.61 SCF
132 nails
Oil-Free
13 - ENG
SOLUTIONS
Tighten screws.
Install Overhaul Kit
(Part # 60117).
Verify adequate air supply.
Install Overhaul Kit
(Part # 60117).
Tighten screws.
Install Overhaul Kit
(Part # 60117).
Verify approved fasteners
of correct size.
See Clearing a Jammed Nail.
Verify fasteners are loaded
correctly. See To Load Tool.
Replace damaged fasteners.
See To Load Tool.
Clean magazine.
Install Driver Maintenance
(Part # 60118).
Reload fasteners to
begin firing again.
Contact a PORTER-
CABLE Authorized
Warranty Service Center