Remote Control Operations; Inserting The Remote Control Batteries - LG WL Serie Manuel D'utilisation

Remote Control Operations

Remote Control Operations
1
POWER
Operation starts when this button is pressed and
stops when you press the button again.
2
TEMPERATURE CONTROL
The thermostat monitors room temperature to
maintain the desired temperature.
The thermostat can be set between 16°C~30°C.
The unit takes an average of 30 minutes to adjust the
room temperature by 1°C.
3
OPERATION MODE SELECTOR
Select cooling mode to cool the room.
Select energy saver mode for energy saving
operation.
Select fan mode for basic ventilating fan operation.
Select dry mode for dry operation.
AUTO RESTART
In failure of electric power, the unit runs as previous setting operation.

Inserting the Remote Control Batteries

1
Push out the cover on the back of the remote control with your thumb
2
Pay attention to polarity and insert two new AAA 1.5V batteries.
3
Reattach the cover.
: Do not use rechargeable batteries. Make sure that both batteries are new.
NOTICE
• In order to prevent discharge, remove the batteries from the remote control if the air
conditioner is not going to be used for an extended period of time
Keep the remote control away from extremely hot or humid places.
To maintain optimal operation of the remote control, the remote sensor should not be
exposed to direct sunlight.
• The remote control can be mounted on a wall using the mountable holder.
4
FAN SPEED SELECTOR
For increased power while cooling, select a higher
fan speed.
3 steps: High Low
5
ON/OFF TIMER
The timer can be set to start and stop the unit in
hourly increments (up to 12 hours).
6
REMOTE CONTROL SENSOR
7
SLEEP MODE
• Press the sleep mode button to set the time you
want the unit to turn off automatically.
• Every time you push this button, the remaining time
will be set as follows. (1Hour
4Hours 5Hours 6Hours
1Hour 2Hours ...)
Operating Instructions
Med
2Hours 3Hours
7Hours 0Hours
Owner's Manual 9