Danby DAC6010E Guide D'utilisation Et Soins De Propriètaire page 30

Consignes d'utilisation
USING THE REMOTE
CONTROLLER
BUTTONS
All manuals and user guides at all-guides.com
ON/OFF
TEMP
S
UP
ENERGY
SAVER
FAN
CLEAN
AIR
NOTE:
To cancel the TIMER setting, push the TIMER button until 0 hour is
displayed on the LCD window of the air conditioner.
ON/OFF
TEMP
S
UP
ENERGY
SAVER
FAN
1
CLEAN
AIR
ON/OFF
TEMP
S
UP
ENERGY
SAVER
FAN
CLEAN
AIR
29
TIMER OPERATION
To set the Auto-start time.
1) Push the TIMER button when the unit is
MODE
operational, only the Auto-stop feature
can be set.
2) Keep pressing the TIMER button, each
TEMP
DOWN
press will increase the selected time by
1
1 hour increments, up to 12 hours.
TIMER
3) The time can be set in a range of 0~12
hours.
4) After the desired time has established,
SLEEP
wait for about 10 seconds until the
setting temperature reverts back in the
display window of the air conditioner.
This indicates the program is set.
CLEAN AIR OPERATION
When this button is pressed, the ion gener-
ator is energized and will help remove
MODE
pollen and impurities from the air. Press it
again to stop the operation.
TEMP
DOWN
TIMER
SLEEP
ENERGY SAVER OPERATION
1
In this mode, the fan will continue to
run for 3 minutes after the compressor
MODE
shuts off. The fan then cycles on for 2
minutes at 10 minute intervals until the
room temperature is above the set
TEMP
DOWN
temperature, at which time the compressor
turns back on and cooling stars.
TIMER
SLEEP