TechniSat DIGITRADIO Car 1 Mode D'emploi page 58

7. Troubleshooting
Symptom
No Display, no function
E
No sound via LINE OUT
Sound is available, but
there are some
inteferences audible at
low volume music
58
Possible cause and solution
The ignition of car is not active.
Please power on the car ignition to powersupply the 12 Volt car plug.
Device does not fit correctly on the cigarette holder.
Please check, if the cirgarette holder is pluged correctly in the 12 Volt
car connector. Please check, if the DIGITRADIO is correctly fitted to the
cigarette holder.
The fuse of cigarette holder is defect.
Please controll the LED of the cigarette holder . It should show "Charge"
If not, please check the fuse of cigarette holder
Fail in cable connection. Please make sure, that the 3,5 mm audio au-
dio cable is connected with the correct LINE OUT plug on DIGITRADIO.
Volume is set to minimum.
Please check the volume settings on you car radio system.
Please check the volume settings on DIGITRADIO (please see 6.5)
Poor DAB+ reception
Please make ensure the sufficient DAB+ reception conditions.
Please change the location if possible and please start a new DAB scan.
Volume setting on DIGITRADIO too high
Decrease the volume output on DIGITRADIO (chapter 6.5).
Increase the volume of car radio system instead.