Berger Move Notice page 23

SYMPTOM
Power inserter No power to the Power
light does not Inserter.
come on.
The satellite could not be
located, reasons for this
include:
• A line of sight obstruction
between the antenna and
the satellite. (Maybe due
to incorrect orientation of
handle)
• Surface may be too
uneven for the Move to
Solid red light on
overcome.
Power Inserter.
• Surface may be unstable.
Error with your F to F lead
connection between the
antenna and the control
box.
Power Inserter Problem with connection
indicates a satellite between the Power Inserter
has been found and receiver, or receiver
with a solid LED and TV.
light after se-
arching;
Receiver isn't set to correct
however my TV
satellite.
has no picture.
ENGLISH ENGLISH
TROUBLESHOOTING
POSSIBLE CAUSE CAUSE OF ACTION
Verify power supply is properly
connected to Move Power
Inserter.
Move unit to have a better view of
the Southern sky and rescan.
Inclement weather can occasionally
cause loss of signal. Wait till weather
improves and re-scan.
Move the unit to flatter ground and
re-scan.
Move unit to a more stable surface
to ensure it doesn't move whilst
scanning.
There is no powering on. After moving
antenna, pressing button will start a
new scan.
Ensure the 'F' lead is properly connected
using the diagram on page 5.
Power inserter can't be turned off;
power supply would have to be discon-
nected.
Set receiver to correct satellite
using receiver manufacturers owners
manual.
23 23