Tectro TBH 570-2 Manuel D'utilisation page 149

4. The desired temperature has now been set. After 3 seconds, the display will
automatically return to normal operating mode.
5. The procedure for changing the temperature is now complete.
6. The desired temperature can also be set using the remote control. See sec-
tion 4.8 for instructions on using the remote control.
The desired temperature can be set anywhere between 7ºC and 40ºC.
4.5 CHANGING THE HEAT OUTPUT OF THE STOVE
1. Push button 2 once. The display will show "pot" and one of the 5 heat out-
put levels.
2. Push button 1 to reduce the heat output setting. The display will show the
new output setting.
3. Push button 2 to raise the heat output setting. The display will show the
new output setting.
4. Once the display has shown the new output setting, 3 seconds later the dis-
play will automatically return to normal operating mode.
5. The procedure for changing the heat output setting is now complete.
6. The desired heat output can also be set using the remote control. See sec-
tion 4.7 for instructions on using the remote control.
4.6 STANDARD SHUT-DOWN
The stove can be switched off by pressing button 3 until "OFF" appears in the dis-
play. During the shutdown phase, the supply of wood pellets to the combustion
chamber is stopped and the room air circulation blower is switched off. The smoke
extraction blower will continue to run for a short time, switching off after the
cooling-down phase.
4.7 REMOTE CONTROL (TBH 570 / TBH 572)
How to use the remote control:
1. Point the remote control at the stove's control panel.
2. Check that there are no obstacles between the remote control and the sig-
nal sensor on the stove.
3. Each mode that can be selected using the remote control must be confirmed
with the
ECONO
TURBO
confirm the selected option.
ON/OFF: Use this mode to switch the stove and the remote control on or off.
ECONO SEND
Hold the button down for at least 2 seconds to switch the system on or off.
Press
TURBO
ECONO SEND
ECONO SEND
TURBO
ON 1 AUTO
OFF 1
ON 1 AUTO
TURBO
UP / DOWN: Use these buttons to set the desired temperature. The tempera-
ON 2 CANCEL OFF 2
ON 2 CANCEL
AUTO ture can be set between 7ºC and 40ºC.
ON 1 OFF 1
CANCEL
ON 2 OFF 2
FAN: Select the desired speed
ECONO SEND
A = Automatic mode
TURBO
Speed 1 (on1)
AUTO
ON 1
OFF 1
ON 2 CANCEL OFF 2
button. An acoustic signal will sound after each selection to
SEND
ON 1 AUTO
OFF 1
ON 2 CANCEL OFF 2
to confirm.
OFF 1
OFF 2
4
149