Unpacking Your Microdrawer; Microwave Oven; Important Notes To The Installer; Important Notes To The Consumer - Thermador MicroDrawer MD24WS Guide D'installation

Unpacking Your MicroDrawer

• Remove all packing materials from inside the MicroDrawer
wave oven. DO NOT REMOVE THE WAVEGUIDE COVER. The
Waveguide cover is a cardboard-like dark grey sheet about 9x10
inches that is attached to the MicroDrawer
• Check the drawer for any damage, such as misaligned or bent
drawer, damaged drawer seals and sealing surfaces, broken
or loose drawer guides and dents inside the cavity or on the
front side of the drawer. If there is any damage, do not operate
the MicroDrawer

microwave oven

®
THERMADOR AUTHORIZED SERVICER.
®

Important Notes To The Installer

• Read and understand the contents of this Installation Manual before
installing the MicroDrawer
• Remove all packing material before connecting the electrical supply.
• It is the responsibility of the owner and the installer to assure compli-
ance with all applicable safety codes and standards. See UL 923,
The Microwave Cooking Appliances.
• The unit may be installed using a standard or flush (inset) installation
per the following instructions.
• Be sure to leave these instructions with the consumer.

Important Notes To The Consumer

Keep this manual with your Use and Care Guide for future reference.
• As when using any microwave oven generating heat, there are certain safety precautions you should follow. These are listed
in the Use and Care Guide. Read all and follow carefully.
WARNING
The appliance should only be installed by a licensed electrician or a qualified technician.
English 6
® microwave oven ceiling.
and contact your dealer or a
® microwave oven.
Microwave Oven
®
Sealing
® micro-
surface
Waveguide
cover
Figure 1
Sealing
surface
Oven cavity