Clearances And Dimensions; Unpacking Your Microdrawer Microwave Oven; Important Notes To The Installer; Important Notes To The Consumer - Thermador MicroDrawer MD24JS Manuel D'installation Et D'instructions

Clearances and Dimensions

• For safety considerations do not install drawer in
any combustible cabinetry which is not in accord
with the stated clearances and dimensions in the
"MicroDrawer™
Microwave Oven
section following. See Figure 3 (standard installation) or
Figure 4 (flush installation).
• Dimensions that are shown in Figure 3 (standard
installation) or Figure 4 (flush installation) must be used.
Given dimensions provide minimum clearance. Locate
electrical outlet in the shaded area in the upper left-hand
corner of the cutout. See Figure 6.
• Supporting surface must be solid and level. Pay special
attention to the floor of the cabinet opening on which
the MicroDrawer™ microwave oven
Unpacking Your MicroDrawer
• Remove all packing materials from inside the MicroDrawer™ micro-
wave oven. DO NOT REMOVE THE WAVEGUIDE COVER. The
Waveguide cover is a cardboard-like dark grey sheet about 9x10
inches that is attached to the MicroDrawer™ microwave oven ceiling.
• Check the drawer for any damage, such as misaligned or bent
drawer, damaged drawer seals and sealing surfaces, broken or
loose drawer guides and dents inside the cavity or on the front
side of the drawer. If there is any damage, do not operate the
MicroDrawer™
microwave oven
THERMADOR AUTHORIZED SERVICER.
®

Important Notes To The Installer

• Read and understand the contents of this Installation Manual before
installing the MicroDrawer™ microwave oven.
• Remove all packing material before connecting the electrical supply.
• It is the responsibility of the owner and the installer to assure compli-
ance with all applicable safety codes and standards. See UL 923,
The Microwave Cooking Appliances.
• The unit may be installed using a standard or flush (inset) installation
per the following instructions.
• Be sure to leave these instructions with the consumer.

Important Notes To The Consumer

Keep this manual with your Use and Care Guide for future reference.
• As when using any microwave oven generating heat, there are certain safety precautions you should follow. These are listed
in the Use and Care Guide. Read all and follow carefully.
• Be sure your MicroDrawer™ microwave oven is installed and grounded properly by a qualified installer or service technician.
WARNING
The appliance should only be installed by a licensed electrician or a qualified technician.
Measurements"
will sit. The floor of
™
and contact your dealer or a
the opening should be constructed of plywood strong
enough to support the weight of the oven (about 100
pounds).
• Check the location where the MicroDrawer™
oven will be installed for proper electrical supply.
• Your oven can be built into a cabinet or wall as a stand-
alone unit or under a built-in gas or electric wall oven.
• Check to be sure that there is a clearance of 2 inches
or greater between the top of the MicroDrawer™
unit and the bottom of a built-in wall
microwave oven
oven above it.
• The microwave interior will easily accommodate a
9" x 13" oblong dish or a bag of microwave popcorn.
Microwave Oven
Sealing
surface
Waveguide
cover
microwave
Sealing
surface
Oven cavity
Figure 1
English 3