Electrical Requirements; Drawer Installation; Bsh Home Appliances Corporation Support - Thermador MicroDrawer MD24JS Manuel D'installation Et D'instructions

Electrical Requirements

The unit requires a 120 volt, 60 Hz, 15 AMP (minimum) circuit. It is recom-
mended that the unit be installed to a separate circuit that serves only this
appliance.
This appliance is fitted with a 3-prong grounded electrical plug. Do not modify the
plug or use an adapter. If the plug does not fit with the available receptacle, have
a licensed electrician install a properly grounded outlet before proceeding with
the installation.
Note: If you have any questions about the grounding or electrical instructions,
consult a qualified electrician or service person.
* Can also be installed using an electrical outlet in an adjacent cabinet within the area
where the provided electrical cord can reach.
Always check electrical codes for requirements.

Drawer Installation

1. Place the drawer adjacent to the wall or cabinet
opening. Plug the power supply cord into the
electrical outlet.
2. Carefully guide the drawer into the prepared
opening. Avoid pinching the cord between the
oven and the wall.
3. Slide the drawer all the way until the mounting
flange makes contact with the face of the cabinet
for standard installation or side cleats for flush
installation. See Figure 7A.
4. Open the drawer. Using the 4 holes on the drawer
as a template, pre drill the cabinet using a 1/16"
bit. See Figure 7A.
5. Secure the drawer with the 4 screws supplied.
See Figure 7B.

BSH Home Appliances Corporation Support

Service
We realize that you have made a considerable investment in
your kitchen. We are dedicated to supporting you and your
appliance so that you have many years of creative cooking.
Please don't hesitate to contact our STAR
Support Department if you have any questions or in the
unlikely event that your THERMADOR
service. Our service team is ready to assist you.
www.thermador.com/support
800-735-4328
English 6
Customer
®
appliance needs
®
Suggested electrical
outlet location*
Figure 7A
Parts & Accessories
Parts, filters, descalers, stainless steel cleaners and more
can be purchased in the THERMADOR
www.thermador-eshop.com
5"
4"
Figure 6
Parts supplied
4 Screws
Figure 7B
Cleat
Mounting
flange
eShop or by phone.
®