Harrie Leenders TRIAS Instructions D'installation page 45

General instructions and regulations
• The installation of the Trias with decorative casing must be carried out by a skilled person employed by a dealer recognized by
Harrie Leenders Haardkachels.
• The casing parts are susceptible to scratching. Handle them gently.
• After the stove has been properly installed, burn some kindling wood to check the draught.
Safety recommendations
• Glass tends to break easily, and broken glass is quite sharp. Take therefore adequate safety precautions.
• For general safety, we refer to guidelines or regulations issued by a relevant official body
Materials and tools required
• 5 mm socket-head wrench
• Set of masonry bits
• Open-end wrench, jaw width 17
• Crosshead screwdriver
• Plumb line
• Sliding pieces
1. Ceiling plate
• Fasten the ceiling plate using the plugs and stucco screws
provided.
• Spirit level
• Handtruck
• Single-walled pipe
• 6 expansion-shell bolts (included)
• 4 S6 plugs (included)
• 4 stucco screws (included)
2. Determining the centre line
• Mark the centre line departing from the saw cut in
the ceiling plate (using the plumb line).
• If the back of the ceiling plate has been removed,
then take 307 mm from the wide side (see sketch).
• 2 M5x8 bolts
• 2 x flat tape
Centre-line
for the
wall
bracket
Saw cut
GB 45