Changing The Filter - Siemens VS Q5 Mode D'emploi

7
Figure
Holding the power cord by the plug, pull out to the
required length and insert the plug into the mains
socket.
! After continuous use of more than 30 minutes,
completely disconnect the power cord from the
power supply.
=> Risk of overheating and subsequent damage.
8
Figure Switching on and off
To switch the vacuum cleaner on or off, press the
ON/OFF button.
9
Figure Controlling the suction level
Turn the rotary control to infinitely adjust the suction
level to the level required.
min - For vacuuming curtains and delicate textiles
- For vacuuming upholstered furniture and
cushions
- For vacuuming delicate rugs und for daily
vacuuming of lightly soiled floors
- For vacuuming durable floor coverings
max - For vacuuming hard floors and heavily soiled
rugs and carpets
Vacuum cleaner with „autoControl"
10
Figure Controlling the suction level
Turn the rotary control to infinitely adjust the suction
level to the level required.
- For vacuuming upholstered furniture and
cushions
- For vacuuming delicate rugs und for daily
vacuuming of lightly soiled floors
- For vacuuming durable floor coverings
autoControl - one setting for all floors. Makes vacu-
uming a breeze, whatever the floor type
max - For vacuuming hard floors and heavily soiled
rugs and carpets
Vacuuming
!
Please note:
Floor tools are subject to a certain amount of
wear,depending on the type of hard floor you have
(e.g. rough, rustic tiles). Therefore, you must check
the underside of the floor tool at regular intervals.
Worn undersides of floor tools may have sharp edges
that can damage sensitive hard floors, such as
parquet or linoleum. The manufacturer does not
accept any responsibility for damage caused by worn
floor tools.
11
Figure
Adjusting the floor tool:
Rugs and carpets
hard floors
12
Figure
Remove the crevice nozzle or upholstery nozzle from
the accessories compartment in the appliance lid.
13*
Figure
Attach the nozzles to the suction pipe or handle as
required:
a)Crevice nozzle for vacuuming crevices and corners,
etc.
b)Upholstery nozzle for vacuuming upholstered
furniture, curtains, etc.
c) Hard-floor nozzle*
- with clip-in edge cleaning bristles:
For gentle but effective cleaning of hard floor
coverings (tiles, parquet, etc.)
- without edge cleaning bristles:
For cleaning dirt in gaps and cracks
The edge cleaning bristles can be removed by
pushing the two catches in the direction of the
arrows.
14
Figure
After use, place the crevice or upholstery nozzle back
into the accessories compartment in the appliance
lid.
15
Figure
You can use the nozzle parking aid on the back of the
appliance if you wish to stop vacuuming for a short
time.
Once you have switched off the appliance, slide the
hook on the floor tool into the recess on the rear of
the appliance.
16
Figure
To overcome obstacles, e.g. steps, the appliance can
also be carried by the handle on the appliance body.
When you have finished vacuuming
17
Figure
Pull out the mains plug.
Briefly pull the power cord and release
(The power cord rewinds automatically).
18
Figure
To store or transport the appliance, you can use the
storage aid on the underside of the appliance.
Stand the appliance upright. Slide the catch on the
floor tool into the groove on the underside of the
vacuum cleaner.
Changing the filter
! Please note: Always switch off the appliance before
changing the filter.
=>
=>
* depending on model
Vacuuming with accessories
29