Preparing The Nebulizer For Use; Connecting Ac Adapter - Omron COMP A-I-R NE-C801 Mode D'emploi

3. Preparing the nebulizer for use

Warning:
Clean and disinfect the nebulizer kit, mask, mouthpiece or nosepiece before
using them when as follows:
- the first time after purchase.
- if the device has not been used for a long period of time
- if more than one person uses the same device
For directions on cleaning and disinfecting refer to Section 5 (page 18-20).
Note: Make sure that the air filter is changed regularly. Refer to Section 7
"Changing the air filter" (page 22).
3.1

Connecting AC adapter

1.
Make sure that the power switch is turned off.
Check that the power switch is
in the off (
2.
Inserting the power plug of the
AC adapter into the power
connector on the compressor.
3.
Plug the AC adapter into a
power outlet.
Note: When disconnecting
the AC adapter, unplug
the AC adapter from
the power outlet before
removing the power
connector on the
compressor.
) position.
Power Plug
Power Connector
Power Outlet
EN
11