Tips; Cleaning & Maintenance - Inventum KK600 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5

tips

• High ambient temperatures have a negative effect on energy use. Keep the appliance in a position away from direct sunlight or
other sources of heat.
• Keep ventilation openings free. Clogged openings lead to higher use of energy.
• Try not to open the door too often, especially when the weather is wet and hot. Once you open the door, mind to close it as soon as
possible.
• The space between the shelves and the rear wall of the refrigerator compartment must be unobstructed to allow the cool air to
circulate. Therefore don't place any food items against the back.
• Turn the thermostat to a lower setting when the circumstances allow it.
• Before storing fresh cooked food, make sure the food has cooled at least to room temperature.
• If the gasket is damaged or if it turns out that the sealing is poor, the energy consumption is substantially higher. To restore
efficiency, replace the gasket.
• Always consider the instructions, otherwise the energyconsumption is substantially higher.
6
cleaning & maintenance
CLEANING THE LARDER
Frost settles on the rear wall of the cooling compartment. It is removed automatically.
During the defrosting, the condensate, which can contain contaminants may clog the water
discharge opening. Should it occur, carefully unclog the water discharge opening with the
cleaning plug.
• Turn the thermostat off [OFF] and unplug the appliance.
• Open the door and remove the food. Keep the contents of the larder in a cool place and
wrapped in blankets or newspapers.
• Clean the interior of the appliance. Use warm water and a neutral detergent to prevent
any bad smells occurring. After cleaning, rinse the interior with clean water and rub dry.
• Leave the appliance to dry for 1 to 2 hours. Simply remove the drawers, the glass shelves
and the door compartments to clean them by hand. Do not clean the interior accessories
in the dishwasher.
• Clean the outside of the appliance and the gasket with a soft moist cloth.
• Switch the thermostat on to the right setting. When the larder reaches its correct
temperature, replace the food items.
REPLACING THE LED LIGHTING
This appliance is equipped with a LED light bulb. It can be used for a
long time. In case, the LED bulb is blown, you can replace it yourself.
18
English
1
3
2
4

Publicité

Table des Matières
loading

Table des Matières