Eaton Metalux SSLED-LD1-12-W-UNV-L840-CD1-U Instructions D'installation page 3

Dimming Circuit Installation
1. Open driver bracket of either side of fixture (Figure 10).
2. Identify violet and gray leads of each driver.
3. Remove K.O. & Wire circuit through the hole
(Figure 11).
4. Close driver compartment (Figure 12).
Figure 10.
Driver bracket
Installation Instructions – Steeler LED
J Box (Supplied by others)
Ground wire
QD
Figure 11.
To Dimming circuit
To AC circuit
Figure 12.
EATON
IB507001EN
To Dimming circuit
Installation instructions
3