Remote Control Features - Zephyr Tornado II AK8200AS Guide D'utilisation, D'entretien Et D'installation

FCC Caution:
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface
cables when connecting to computer or peripheral device. This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions. (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
This remote control may operate in humid environments, but not when placed on a wet surface.
SYNCHRONIZATION:
1. With range hood off, press and hold the "lights" button on the range hood until the letter "F" shows on the display screen.
2. Press the "lights" button on the remote, the lights on the hood will turn on. The synchronization is complete.

REMOTE CONTROL FEATURES:

The RF remote control is equipped with a magnet for easy storage. The remote may be placed on any magnetic surface such
as a refrigerator or the Zephyr remote holder. Maximum remote control communication distance from power pack is 15 feet.
Blower On/
Blower On/
1 2
Speed Selection
Power Off
3 4
Lights On/Dim/Off
5 Min Delay Off
+
A
To create a unique link between your range hood and remote control please follow the below steps:
Blower On / Speed Selection
1
Press
Blower On / Power Off
2
By pressing
again and the entire hood will power off, including lights.
Delay Off
3
By pressing
appear in the lower right corner of the hood display
is on. The blower will change to speed 1 and shut down after 5 minutes.
Lights On / Dim / Off
4
Switch lights On by pressing
REMOTE CONTROL MAINTENANCE:
Clean the remote control using non abrasive detergents
Follow instructions below for replacing battery.
Using a small flat head screwdriver, raise the cover of the battery door (A)
in order to access the battery compartment.
-
Remove the battery and replace with Type A23 12V.
Negative end of battery should face the spring inside the remote.
Replace battery door and recycle old battery.
to power on blower and cycle through all six blower speeds.
, the blowers will power on at the last speed setting. Press
, the blower and lights will enter Delay Off mode. A dot will
once, again to dim and again to switch Off.
15
indicating the function