What To Do If - IKEA LAGAN Mode D'emploi

ENGLISH
5
Release the locking
system to remove
the internal glass
panel.
7
2
1
Carefully lift (step 1)
and remove (step 2)
the glass panel.

What to do if...

Warning! Refer to the Safety chapters.
Problem
The appliance does not op-
erate.
The appliance does not op-
erate.
The oven lamp does not op-
erate.
Steam and condensation
collect on the food and in
the oven.
6
Turn the two fasten-
ers by 90° and re-
move them from
their seats.
Possible cause
The appliance is not activa-
ted.
The fuse in the fuse box is
released.
The oven lamp is defective.
You left the dish in the oven
for too long.
Clean the glass panel with water and soap.
Dry the glass panel carefully.
Installing the door and the glass panel
When the cleaning is completed, install the
glass panel and the oven door. Do the
above steps in the opposite sequence.
The screen-printing zone must face the in-
ner side of the door. Make sure that after
the installation the surface of the glass pan-
el frame on the screen-printing zones is not
rough when you touch it.
Make sure that you install the internal glass
panel in the seats correctly. Refer to the il-
lustration.
Activate the appliance. Re-
fer to the chapter "Daily
Use".
Do a check of the fuse. If the
fuse is released more than
one time, contact a qualified
electrician.
Replace the oven lamp.
Do not keep the dishes in
the oven for longer than 15
- 20 minutes after the cook-
ing ends.
11
Remedy