General; Function; Self-Test - Elbro Profi III LED Manuel D'utilisation

Operation
Correct indication is ensured in the tempera-
|
ture range of −10 °C
Always keep the device dry and clean. The
|
housing can be cleaned using a moist cloth.
The additional warning symbol, acoustic indi-
|
cations and vibration for voltages > 35 V are
only for warning of hazardous voltages, not
for measurement.
Before the test, check the audibility of the
|
warning sound at the ambient volume.
Immediately replace the batteries when a con-
|
tinuous warning signal sounds when switching
on.

General

Voltages have priority. If no voltage is applied at the measuring probes
(< 3 V), the device is in the continuous test mode. In stand-by mode, the or-
ange "Rx/" illuminates.

Function

To switch on the device, simply hold the test probes on one another.
Attaching and removing the measuring probe adapter makes it easier to
carry out measurements at the socket.
Indication of the voltage is carried out without the batteries.

Self-test

For the test, keep the probes apart. The green "Rx/" LED must clearly illu-
minate and a beep tone sounds. (After a short period, the device automati-
cally switches off by the "Auto Power Off" function.) If the LED does not illu-
minate, or only faintly illuminates, replace the batteries.
If the device does not function with the new batteries, it must be protected
from misuse.
24
– +55 °C.
ELBRO Profi III LED