Operation; Safety Instructions - Elbro Profi III LED Manuel D'utilisation

Operation

Thank you very much for deciding on the ELBRO Profi III LED, a two-pole
voltage tester with LCD display. DC voltages of 6V to 1400V and AC volt-
ages of 6V to 1000V, polarity, rotating field and continuity tests of up to 50 
can be carried out and FI/RCD tests.
Because of the high protection class (IP65), the ELBRO Profi III LED can
also be used under rugged conditions.

Safety instructions

You have decided on a device that provides a high degree of safety. In order to
ensure safe and correct application, before initial use, it is necessary to
completely read these operating instructions.
The following safety precautions are applicable:
Immediately before using, carry out a function
|
check of the voltage tester (VDE regulation
0105, Part 1). Make sure that the connecting
lines and device are fully serviceable. Check
the device on a known source of voltage, e.g.
230 V socket.
Hereby, if the display fails to indicate one or
|
more functions, do not use the device and it
must be checked by a specialist.
Only hold the device by the handles, avoid
|
touching the probes!
Only carry out checks for isolation from the
|
power supply on both poles!
The device must not be operated in a moist
|
environment!
Do not use with the battery compartment
|
open! Whilst replacing the battery, the meas-
uring probes must be removed from the
measurement circuit.
ELBRO Profi III LED
Operation
23