Getting Started; Time Setting - TFA TIME & LIGHT 60.2029.10 Mode D'emploi

Elements:
LCD Display (Fig.1)
A - Time
C - Night light symbol
D - Charging status symbol
F - Alarm symbol 2
J - Alarm symbol 1
L - Snooze symbol
M - AM/PM in 12-hour format
O - Time symbol
Housing (Fig.2)
A - Night light
C - Micro USB port
Position digital alarm clock
10
Buttons (Fig.1)
B - LIGHT button
+
E - button
G - ALARM 2 button
H - ALARM 1 button
-
K - button
N - TIME SET button
B - RESET button
Position night light

Getting started

Remove the protective film from the display.
Insert the supplied USB cable with the micro-USB plug into the provided opening on the device
(Fig.2-C). Connect the device via the USB cable only to a suitable USB power source.
The device switches on.
Charging
Before the first use, please charge it fully.
To fully charge, leave the device connected for approximately 3 - 4 hours.
The charging status symbol flashes during charging. The charging status of the device is shown on
a symbol with three bars (Fig.1-D).
When the device is fully charged, the charge icon will appear filled. Disconnect the device from the
charging power source.
Do not leave the fully-charged device connected to the charging power source as this may shorten
battery life.
The lowest bar flashes when the battery needs to be recharged.
Please charge the device immediately to preserve battery life.
Recharge the battery every six months, even if the product is not in use.
Switch off the device (press and hold the
you are not going to use it for a longer period of time.
Operation
When entering the setting mode and each successful double-click is followed by a beep.
Press and hold the or button (Fig.1-E, Fig.1-K) in the respective setting mode for quick setting.
The device will automatically quit the setting mode if no button is pressed for 10 seconds.

Time setting

Press and hold the TIME SET button
The time symbol appears (Fig.1-O).
The hour digit flashes on the display. Press the
Confirm with the TIME SET button.
Set the minutes in the same way. Confirm with the TIME SET button.
12- or 24-hour system
Press the TIME SET button (Fig.1-N) twice in quick succession in normal mode to set the 12
HR or 24 HR system. In the 12 Hr system AM or PM (Fig.1-M) (after 12 o'clock) appears on the
display.
and button (Fig.1-E, Fig.1-K) at the same time) if
(Fig.1-N) in normal mode to enter the setting mode.
or button (Fig.1-E, Fig.1-K), to adjust the hours.
11