C - Location Of The Remote Control; Use Of The Appliance; A - Preliminary Operations; B - Appliance Switching On/Off - Olimpia splendid DOLCECLIMA ARIA 8 Mode D'emploi Et D'entretien

Masquer les pouces Voir aussi pour DOLCECLIMA ARIA 8:

Les langues disponibles

3.3.c - Location of the remote control

• Keep the remote control in a position from which

the signal can reach the receiver (29) of the appli-

ance (maximum distance is approx. 3 metres - with

charged batteries) (figure D).

The presence of obstacles (furniture, curtains, walls,

etc.) between the remote control and the appliance

reduces the remote control range.

3.4 - USE OF THE APPLIANCE

Work as follows in order to use the appliance.

To prevent possible damages to the compressor, each start is delayed by 3 minutes

with respect to the last switching off.

3.4.a - Preliminary operations

•

Place the appliance on a stable and not inclined base, at at least 50 cm. from

the wall or from any other object, in order to ensure the correct air circulation.

Place it on a water-resistant surface since the possible water leakage could

damage furniture or the floor.

•

Do not place the appliance directly on carpets, towels, blankets or other absor-

bent surfaces.

•

Insert the plug in the power socket; the appliance emits a "beep" and switches

to stand-by mode.

Before electrically connecting the appliance, make sure the plate data correspond

to those of the electricity distribution network.

3.4.b - Appliance switching on/off

a. The appliance can be switched ON or OFF for short periods by pressing B1 on the remote control or

SW1 on the control panel (if the appliance is switched off for a long period then it should be deactivated

by removing the plug from the mains supply.

b. The respective LED S8 lights up indicating that the appliance is switched on.

c. In this condition, press B1 again on the remote control (or SW1 on the control panel) to restore all the

formerly selected functions.

To set the automatic switching on/off of the appliance, please refer to the paragraph "Timer Mode".

3.5 - COOLING MODE (COOL)

a. Using this mode, the appliance dehumidifies and cools the environment.

This mode can be selected by pressing B7 or SW2 until when the cooling LED (S3) is activated on the

control panel display.

EN - 22

~3m

Table des Matières