Reference; Firmware Upgrade; Upgrade Procedure - Samsung DVD-P390 Mode D'emploi

reference

Firmware upgrade

Introduction
Upgrading the Firmware will keep your DVD player
up to date.
The latest firmware version for this unit is provided
on the Samsung Website.(www.samsung.com).
How to make an upgrade disc
You must burn the latest firmware version onto a
blank CD-R or CD-RW disc:
1. You have to download a new file through
Download Center of Samsung Internet Site
(www.samsung.com).
2. Write the file to Disc using the CD-RW drive of
your computer.
Note
The CD should be burned following specs
below.
- File System CD-ROM ISO Level.
- Character set ISO 9660.
- The burned CD has to be Finalized.
- Please burn the CD at a low speed.

Upgrade procedure

1. Open the disc tray of your DVD-P390.
Place the burned disc on the tray. Close the tray.
The Firmware upgrade screen will appear.
Firmware upgrade
menu appears
54_ reference
2. Press the √/® buttons to select Total, then
press the ENTER button.
Firmware upgrade starts
- During the firmware upgrade process, the
tray will open.
Please remove the disc and wait for about
2 minutes.
- If the DVD player was successfully updated,
the disc tray will close and the unit will turn
off and on.
When the unit turns on, the Select Menu
Language screen will appear.
3. Press the π/† buttons then press ENTER to
select the desired language.
Note
- If the "Select Menu Language" doesn't
appear, please contact Samsung Customer
Service. (see page 57)
- Do not press any button or unplug the
power cord during the upgrade.
- The upgrade procedure may change, refer
to the web site (www.samsung.com).
English
Français
Deutsch
Español
Italiano
Nederlands