Kreg KMA4500 Mode D'emploi page 10

3 Align the Cutline Indicator Arms
a. On the cutline indicator stop (G), loosen the indicator thumb screw (BB) and slide
the cutline indicator arm (F) out to align to the edge of the material. Slide the
stop to the clamp edge and re-tighten the thumb screw (BB).
b. Repeat for the other cutline indicator arm to ensure you have aligned both arms
to the edge of the material.
c. Remove the guide from the material after both cutline indicator arms have been
aligned. Refer to Step 5 in the Operation section of the manual.
Note By setting the length of the cutline indicator arms, you have now accounted
for the blade offset of your saw. This means the cutline indicator arms are calibrated
to this specific saw. If you change tools, you may need to recalibrate the guide.
Note To calibrate for use with a jigsaw, repeat steps 1-3 above, but align the jigsaw
blade with the edge of the material, instead.
10
F
G
BB