VINCENT PHO-8 Manuel D'utilisation page 22

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CONNECTION OF THE RECORD PLAYER (TURNTABLE)
Connect the audio cable of the record player to the RCA sockets "MC/MM IN" (7) of the PHO-8.
Establish a tight connection of the grounding cable at the clamp "GND" (8). Some record players are not
equipped with a separate grounding cable.
RCA-connection
PHO-8
CONNECTION OF THE AMPLIFIER
Connect the output sockets "OUT" (9) of the PHO-8 to a standard line level input of your integrated ampli-
fier or preamplifier. These inputs are in most cases named "CD", "TUNER", "AUX", "S1" or "LINE1".
Do never connect an amplifier input that is named "PHONO"!
PHO-8
RCA connection
integrated amplifier,
preamplifier or receiver
LINE IN
CONNECTION OF THE POWER SUPPLY
The purpose of the PHO-8ps is to convert the mains alternating power to a low DC voltage that is more
appropriate to supply the phono preamplifier PHO-8. So in the first place both devices must be intercon-
nected using the supplied 5pin DIN cable (6)(10). Check whether the wall mains socket provides the
appropriate mains power, which is the case if it is supplied with 230 V AC 50 Hz. After all other cable
connections have been made push the plug of the supplied power cable firmly into the power socket (4)
on the back of the appliance. Plug the other end of the power cable into a mains socket.
Always switch on the PHO-8 before you switch on the amplifier/preamplifier!
Vincent
22

Publicité

Table des Matières
loading

Table des Matières