Troubleshooting Guide - Avanti Elite WCSE47R3S Manuel D'instructions

You can solve many common appliance problems easily, saving you the cost of a possible service
call. Try the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
Not plugged in.
Unit does not The appliance is turned off.
operate. The circuit breaker tripped or a blown
fuse.
External environment may require a
higher setting.
Unit is not cold
The door is opened too often.
enough.
The door is not closed completely.
The door gasket does not seal properly.
The room temperature is hotter than
normal.
A large amount of contents has been
The compressor added to the unit.
turns on and off The door is opened too often.
frequently. The door is not closed completely.
The temperature control is not set
correctly.
The door gasket does not seal properly.
In order to circulate the air and maintain the set temperature inside the cabinet the
fans must cycle on and off even when the compressor is off. The fans will cycle ON
The fans turn on and OFF while the compressor is off approximately every 10 seconds, this is called
and off frequently. "Semi-speed status". This cycle is normal and meant both to circulate the air as
well as ensure the continued operational status of the fans.
completely and does not complete this cycle the fan is non-operational.
Not plugged in.
The light does not The circuit breaker tripped or a blown
work. fuse.
The light button is "OFF".
The unit is not levelled
Vibrations. The bottles are vibrating.
There is an object under the Unit.
The unit seems to
make too much The Unit is not level.
noise.
The Unit is not level.
The door
The door will not
properly installed.
close properly.
The gasket is dirty.
The shelves are out of position.
Error Code:
E1-E2-E3- A sensor has failed.
E4-E7-E8

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE
was reversed and not
18
SOLUTION
Plug the unit.
Press to turn on the unit.
Check the breaker and/or fuses.
Check the temperature control setting.
Close the door properly.
Check the door gasket.
Close the door properly.
Check the door gasket.
Plug the unit.
Check the breaker and/or fuses.
Check to assure that the Unit is level.
Make sure the bottles don't touch each
other.
Remove the object.
Level the unit.
The rattling noise may come from the
flow of the refrigerant, which is normal.
As each cycle ends, you may hear
gurgling sounds caused by the flow of
refrigerant in your unit. Contraction and
expansion of the inside walls may
cause popping and crackling noises.
Level the unit.
Close the door properly.
Clean the door gasket.
Place the shelves properly.
Contact us for a service call.
If the fan stops