Installing Stainless Steel Handle - Avanti Elite WCSE47R3S Manuel D'instructions

Installing the stainless steel handle
This appliance includes a stainless steel handle. To install the handle please follow the below
instructions:
1. Pull away the door gasket in the area where the handle is to be installed on the left side as
shown below in Illustration # 1.
necessary.
2. Align the handle with the screws installed.
screwdriver until the handle sets both flush and secured tightly against the door frame. (DO
NOT over tighten as this will cause damage to the handle assembly).
3. Replace the door gasket to its original position.
4. If you choose not to use the handle supplied, simply follow step 1 to access the installation
screws and remove them and then place the two decorative plugs into the two holes
separately. Continue on to step 3 to replace the door gasket to its original position.
Illustration # 1
1. Gasket
2. Phillips Head Screw
The gasket is easily displaced by hand, no tools are
Tighten the screws using a Phillips head
3. Phillips Head Screw Driver
4. Handle
11
Illustration # 2