Changing Tools - EINHELL EBH 500 E Notice D'utilisation

Anleitung EBH 500 E
Caution:
Drill bits should be tightened by
all three holes in the drill chuck.
After securing, remove the
chuck key.
(Not included)
Drilling depth limit stop
Caution:
For safety reasons, always use the
additional handle while working.
Ear protection is recommended, as
the noise level exceeds 85 dB
when operating.
Where a safety helmet when
working over head.
14.11.2001 11:00 Uhr Seite 7

Changing tools

1. Push back the collar.
2. Depending on the tool seat,
turn the collar clockwise or
counterclockwise.
3. Insert the tool.
4. Release the collar and make
sure it correctly locks in place.
Quick closing chuck for SDS-Plus
Turning the speed adjuster
clockwise increases rotational
speed.
On-Off switch
Turning on:
Press operating switch A
Continuous operation:
Secure switch A with the locking
switch B
Turning off:
Briefly press operating switch A
By applying more or less pressure to operating switch A,
you can select the proper rotational speed for any job (for
example screwing, drilling, etc.).
GB
7