Preparation For Use; Handling; Error Messages; Technical Data - ADE Letitia Mode D'emploi

Thank you for your decision to purchase this high quality product of ADE Germany. You
bought a scale featuring highest technical standard and well-proven quality. Please read
this instruction manual prior to the start up and keep it careful to have this information on
hand whenever needed.
1.

Preparation for use

Insert battery:
Open the battery cover at the bottom side of the scale and insert the supplied battery
(1 x 9 V). Please ensure the correct polarity of the battery ( +/- ).
2. Safety guidelines:
Please care that no heavy object may fall on the scale.
Otherwise, the scale may become damage.
könnte.
Clean the scale only by using a slightly damp cloth. Do not use
solvents or abrasive cleaning agents.
All parts of the scale should be cleaned immediately after
contact with fat, spices, vinegar, and other heavily spiced or
coloured food. Avoid contact with citric acid.
Do not submerge the scale under water.
Please note that only the bowl is dishwasher safe.

2. Handling

Switch-on the sca le:
Push the ON/OFF-key. At first, the display indicates all characters and the scale starts a
self-test while a signal runs. A short peep-tone will sound and the display indicates: top
left " 00:00" (timer), top right e.g. 24.0 °C (room temperature), down left " ZERO" (zero
indication), down right " 0 g" (weight indication). Now the scale is ready to use.
Automatic- / manua l switch-off the scale
If the indicated weight does not change within two minutes, the scale will automatically
switch-off.
To save the battery you can switch-off the weighing function manually by pushing the
ON/OFF-key.
2
Units of weight:
It is possible to change the unit of weight for country specific setting (kg/g =
kilogram/gram to lb/oz = pound/ounce) by pressing the UNIT-key. Please pay attention to
use the scale under consideration of your country specific unit of weight.
Tare-func tion:
Use the Z/T-key to set the scale to " 0 g" . Place for example a bowl on the weighing
platform. Upon the weight is indicating press the Z/T-key to set the indication again to " 0
g" and the display indicates " TARE" . This process is repeatable until the max. capacity of
the scale (5 kg) has been reached. After removal of the loading, the total weight will be
shown as minus indication (TARE).
Set-up timer:
Push the ON/OFF-key to switch-on the scale. Afterwards push T-SET-key. A little bell
appears top left in the display. Now you can set the requested time by using Z/T-key (
plus) or UNIT-key (‚ minus). After enter the time push T-SET-key again and the scale will
return to the weighing function. The timer runs and after expiry of time a loud peep-tone
sounds for 60 seconds (if not stopped before by pushing Z/T-key).

3. Error Messages

" Lo" = Battery used up - Please replace the battery with the intended
type (1 x 9 V).
" Err" = Overload - The weight exceeds the maximum capacity of
5 kg. Please immediately remove the critical load to avoid load cell
damage.

4. Technical Data

Capacity x graduation: max. 5 kg x 1 g
Dimensions: 215 mm x 215 mm x 145 mm
Batteries: 1 x 9 V (included)
Subject to technical modifications

5. Warranty

ADE warrants for a period of 3 years from the date of purchase that it will remedy any
defects due to faulty material or workmanship free of charge by repair or replacement.
When purchasing, please have the warranty coupon signed and stamped by the dealer.
When making a guarantee claim, please return the scale together with the guarantee card
including the reason of complaint to your dealer.
3