BE GX390 Mode D'emploi page 8

Discharge
Lift
Placing Strainer Basket Into Water Source
Place strainer basket into water to be pumped. Basket must be fully
immersed.
NOTICE
Improper treatment of water pump can damage it and shorten its life.
•
NEVER operate pump without strainer connected to end of
suction hose.
•
Keep strainer out of sand or silt, place in bucket or on stones.
•
DO NOT let pump run dry or damage to seals may result.
14
OPERATION
Total
Lift
Suction
Lift
WWW.BEPOWEREQUIPMENT.COM
OPERATION
Prime the Water Pump
1. Remove priming plug from top of pump.
2. Fill pump with clean, clear water up to top of discharge outlet.
3. Replace priming plug, ensuring that the seal is tight.
NOTICE
Improper treatment of water pump can damage it and shorten its life.
•
Be sure chamber is filled with water before starting the engine.
•
NEVER run pump without priming
During priming process water will slowly move up suction hose. Operator
may need to continue to add water into pump to keep prime. Once water
from suction hose reaches the pump, it will run normally and transfer
water at high volume. It is essential the operator ensures this process is
complete to prevent failure of prime or damage to pump.
WWW.BEPOWEREQUIPMENT.COM
15