Dimplex XLF50 Manuel Du Propriétaire page 21

Operation
• Indicated by the heater running
at full heat, for a user set
amount of time, to quickly heat
up a cold room/space. The
Heat Boost can be set for a
maximum of 20 minutes, in
5 minute increments.
Disable Heat
If desired, depending on the
season, the heater on the unit can
be disabled. The function of the
remaining controls will continue
to function as outlined in this
manual.
Pressing the
on the manual controls at the
same time and holding for 2
seconds will disable and enable
the heater.
! NOTE: When the heater has
been disabled and any of the
heat related functions are used,
the Display will indicate "---".
If the Permanent Heat Disable
has been activated by removing
the jumper on the main PCB, the
display will indicate "H--".
H. Color Themes
Different presets of lighting color
combinations are available in
the unit.
www.dimplex.com
and buttons
Changed by repeatedly pressing
the corresponding button on the
remote or the unit.
• Cycles through the different
preset light settings of the
unit, this includes different
combinations of colors of the
flame base and media lighting.
! NOTE: Two of the themes in
the cycle are a prism where the
unit cycles through a variety of
colors. Pressing the
the cycling and holds the unit on
the preferred color, indicated by
a solid circle. When the unit is
on prism, and is cycling through
the colors, a rotating circle will
be displayed.
I. Brightness
Changes the Brightness of the
lights in the unit.
Adjusted by repeatedly pressing
the corresponding button on the
remote or the unit.
• Indicated by the second digit
on the Display changing to
show: "H" (high), and "L" (low).
stops
21