Eco Operation - Dimplex XLF50 Manuel Du Propriétaire

Operation
! NOTE: The heater may emit
a slight, harmless odor when
first used. This odor is a normal
condition caused by initial
heating of internal heater parts
and will not occur again.
D. Temperature Down
Decreases the temperature
setting.
Adjusted by repeatedly
pressing the corresponding
button on the remote.*
• Indicated by setpoint
temperature on the Display
decreasing and the speed of
the fan decreasing to reduce
the amount of heat being
projected into the room.**
E. Temperature Up
Increases the temperature
setting.
Adjusted by repeatedly
pressing the corresponding
button on the remote.*
• Indicated by the setpoint on
the Display increasing and the
speed of the fan increasing to
increase the amount of heat
being projected into the room.**
20
* The first time the button is
pressed the current temperature
set point will be displayed for
2 seconds.
** The temperature can be
adjusted from 5 °C to 37 °C
(41 °F to 99 °F).
! NOTE: Holding the
the buttons down for
two seconds on the manual
controls will change the
temperature scale from °C to °F,
or vice versa.
F.

Eco Operation

Runs the heater in a reduced
wattage range when activated.
Adjusted by pressing the
corresponding button on the
remote when the heater is on.
• Indicated by the Display and a
reduced fan speed.
G. Heat Boost
Turns the Heater Boost On and
Off. Runs the unit at the full rated
wattage.
Activated and adjusted by
repeatedly pressing the
corresponding button on
the remote.
and
www.dimplex.com