Protect Against Freezing - GE GDF530 Serie Manuel Du Propriétaire

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Care and cleaning
Filters
Inspect and clean the filters periodically. This should be done every other month or more depending on usage. If
there is a decrease in wash performance or dishes feel gritty, this is also an indication the filters need to be cleaned.
The retaining posts can be a choke hazard for small children if removed from the dishwasher.
WARNING
Keep out of reach of children.
Ultra-Fine Filter Assembly
To clean the Ultra-Fine Filter assembly, remove the
bottom rack. Twist the Ultra-Fine Filter assembly
counterclockwise and lift to remove for cleaning. Rinse
filter with warm soapy water and use a sponge to
carefully remove any stubborn particles.
For models with a 2-piece Ultra-Fine Filter assembly with
an additional Filter Basket for food particles, twist the
Filter Basket in the counterclockwise direction to unlock
it from the Ultra-Fine Filter assembly. See directional
arrows on the bottom of the Filter Basket. Pull the Filter
Basket to remove from the assembly, throw away any
food particles, rinse with warm soapy water, and use a
sponge to remove any stubborn particles.
2-piece - Ultra-fine Filter assembly with additional Filter Basket
(on some models)
Once cleaned, replace Filter Basket back into the
Ultra-Fine Filter assembly and twist it clockwise to lock
into place.

Protect Against Freezing

If your dishwasher is left in an unheated place during the
winter, ask a service technician to:
1
Turn off electrical power to the dishwasher. Remove
fuses or trip circuit breaker.
2
Turn off the water supply and disconnect the water inlet
line from the water valve.
Does Your Dishwasher Have an Air Gap?
An air gap protects your dishwasher
against water backing up into it if a drain
clogs. The air gap is not a part of the
dishwasher. It is not covered by your
warranty. Not all plumbing codes require
air gaps, so you may not have one.
49-4000239 Rev 1
Fine Filter
To clean the Fine Filter (mesh plate), remove the bottom
rack. Remove the Ultra-Fine Filter.
Twist each of the two retaining posts located toward the
back bottom of the tub counterclockwise, and remove the
Fine Filter. Rinse filter with warm soapy water. Scouring
pads or brushes can scratch the filter surface but a soft
brush or sponge may be needed to remove stubborn
soils or calcium deposits caused by hard water. Once
cleaned, replace the Fine Filter and the Ultra-Fine Filter.
Twist the two retaining posts clockwise to lock in place.
Drain water from the water inlet line and water valve.
3
(Use a pan to catch the water.)
4
Reconnect the water inlet line to the water valve.
The air gap is easy to clean.
Air gap
1
Turn off the dishwasher and lift off the air gap cover.
2
Remove the plastic cap under the cover and clean with a
toothpick.
Check the air gap any
time your dishwasher
Replace the cap and cover when the air gap is clean.
3
isn't draining well.
Retaining
Posts
Fine
Ultra-Fine
Filter
Filter
Spray
Arm
17

Publicité

Table des Matières
loading

Table des Matières