Troubleshooting Guide - Scheppach MTE380 Traduction Des Instructions D'origine

14. Troubleshooting guide

Fault Possible causes
• No electricity in plug
Motor does not start
• Cable defective
• Switch, switch/plug block defective
• Connections to motor or capacitor
disconnected
• Blade roller blocked
• Soil is too firm
Engine performance
• Carbonbrushes worn out
drops
• Roller badly worn
The Electric Tiller is
• roller worn
difficult to check. • Wrong working depth
Motor is running, roller • Gearing defective
is not rotating
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Rectification
• Check line and fuse
• Have machine checked by a customer service
center
• Have machine checked by a customer service
center
• Have machine checked by a customer service
center
• If necessary adjust working depth. Clean housing
so that the roller can run freely
• Change working depth
• Check by a customer service center
• Replace roller
• Replace roller
• Correct working depth
• By customer service workshop
GB | 27